VT#: 32-3601

Front turn signal 36" extension harness for all 2011-up FXST , FLST, and 2012-up FXD models with turn signals mounted under the handlebar switch housing. This extension harness will allow the installation of taller than stock bars and the relocation of turn signal assemblies. The only way to move the turn signals is to cut the turn signal wiring that is hard wired into the circuit board installed in the handlebar switch housing. This harness will allow you to cut the wiring, heat shrink the cut wire to prevent a short, solder on extension harness and simple connect the other end of the harness into the factory connector located under the fuel tank.

FXST Softail® 2011-UP
FLST Heritage Softail® 2011-UP
FXD Dyna Glide® 2012-UP